4-Way Lumbar Support, Removing and Installing

4-Way Lumbar Support, Removing And Installing







1 - 4-way lumbar support
- Remove seat.
- Pry cover fastening strip out of backrest trim.
- Unclip backrest trim with clips.
- Pull backrest trim downward and out.
- Detach Bowden cable - 6 - for lumbar support adjuster - 2 - at retaining pin - 9 -.
- Detach Bowden cable - 7 - for lumbar-support height adjuster - 3 - at retaining pin - 8 - and guide roller - 10 -.
- Detach top left and right wire clips - 11 - at retaining clips - 12 -.
- Detach bottom left and right wire clips - 13 - at retaining clips - 14 -.







2 - Lumbar support height adjustment motor
- Remove backrest trim.
- Disconnect connector.
- Remove screws - 4 - (2x).
- Detach Bowden cable at lumbar support.
- Unclip clip - 16 -.
3 - Lumbar support adjustment motor
- Remove backrest trim.
- Fold back backrest cover around lumbar support adjustment motor - 2 -.
- Disconnect connector.
- Remove screws - 5 - (2x).
- Detach Bowden cable at lumbar support.
- Cut through cable tie - 15 -.







4 - Screws (2x)
5 - Screws (2x)
6 - Bowden cable
7 - Bowden cable
8 - Retaining pin
9 - Retaining pin
10 - Guide roller
11 - Wire clip
12 - Retaining clip
13 - Wire clip
14 - Retaining clip
15 - Cable tie
16 - Clip