From CW 35.99

Airbag Control Module -J234- (from CW 36.99 On), Removing And Installing

WARNING: Observe all safety precautions before starting work on any part of airbag system.

See Caution before beginning repairs on the electrical system
- Disconnect battery Ground (GND) strap/cable.
- Remove front section of center console.







- Remove connecting pieces for air ducts to rear left and right footwell vents.
- Open cable tie - 4 -.
- Remove bolts - 3 - (3x).
Tightening torque: 6 Nm (53 in.lb)
- Pull out control module - 1 -.
- Release retainer on connector - 2 -.
- Pull connector - 2 - out of control module - 1 -.
- Remove control module.

See Caution for connecting Telematics battery.

NOTE: If control module is replaced, it must be coded.

- After connecting battery, check vehicle equipment (radio, clock, power windows) as per Repair Manual and/or Owner's manual.
- If the airbag Malfunction Indicator Lamp (MIL) -K75- signals a malfunction after assembling then the DTC memory must be erased and checked again with VAG 1551 scan tool.