Vehicles From 36.98 Through 22.00
Code Control Module (Function 07)
NOTE:
- As-delivered control module is not coded.
- Airbag fault lamp is always lit if control module has not been coded.
- Coding is performed with VAG 1551 Scan Tool (ST).
- For complete procedure on disabling and enabling rear side airbags
If V.A.G 1551 does not display appropriate code or if control module is replaced, perform control module coding as follows:
Implementing function "07 - Code Control Module"
Indicated on display:
Rapid data transfer HELP
Select function XX
- Press keys 0 and 7.
Indicated on display:
Rapid data transfer Q
07 - Code Control Module
- Confirm entry with Q key.
Indicated on display:
Code Control Module
Enter code number XXXXX (0-32000)
- Enter airbag control module code via keypad.
Code: 00104
Vehicles from 36.98 through 22.00:
NOTE:
For technical reasons, the chassis number range 4BWN 024500 to 4BWN 033300 may feature non-operational seat occupied and belt fastened sensors in certain cases.
If a belt buckle in the above chassis number range has to be replaced, fit a buckle with no belt fastened sensor.
In the event of a seat occupied sensor fault, disconnect the sensor and code the airbag control module in the same way as for a vehicle with no seat occupied sensor.
Indicated on display:
Code Control Module Q
Enter code number 00104 (0-32000)
- Confirm entry with Q key.
- Control module identification appears on display together with code entered (00104).
460959855C Airbag 7 AUDI 0000 ->
Code 00104 WSC 08812
- Control module identification appears on display together with code entered (00004).
4B0959655 Airbag 6 AUDI 0000 ->
Code 00004 WSC 08812
NOTE: Codes 00104, 00106, 00204, 00206, 00205, 00207, 00115 and 00117 are only possible with control module number "4B0959655C" or "4B0959655J".
Explanatory notes on display. Check Control Module Versions (Function 01)
- Press -> key.
Indicated on display:
Rapid data transfer HELP
Select function XX
- Press keys 0 and 6 to terminate function.
Indicated on display:
Rapid data transfer Q
06 - End Output
- Confirm entry with Q key.
Indicated on display:
Rapid data transfer HELP
Enter address word XX
Coding table for airbag control module:
