Rear Axle

ABS wheel speed sensor, removing and installing

Removing
- Switch ignition off.
- Lift rear seat bench out of locking mechanism.





- Disconnect ABS wheel speed sensor harness connectors and push out grommet (arrow).
- Raise vehicle.
- Pull ABS wheel speed sensor out of wheel bearing housing.
- Disconnect ABS wheel speed sensor wiring from retainers.
- Remove ABS wheel speed sensor wiring downward together with grommet.
When installing, pay particular attention to the following points
- Replace clamping sleeve, Refer to Antilock Brakes and Traction Control; Service and Repair.
- Connect ABS wheel speed sensor wiring and snap grommets into retainers.