Left Rear Level Control System Sensor, Removing and Installing

Removing (front-wheel drive)





- Disconnect electrical connector.
- Remove level control sensor from bracket -2- and linkage -3- by removing nut -4- and both Allen screws (3 mm) at level sensor -1-.
- Remove bolt at rear axle and remove linkage -3-.

Installing
- Install in reverse order of removal.


Removing (all-wheel drive)
The level control sensor is mounted on the left control arm of the rear axle.
- Disconnect electrical connector.





- Remove level control sensor -2- from bracket -3-.
- Disengage linkage -4- by removing nut -1-.
- Remove linkage -4- by removing nut -5- at control arm.

Installing
- Install in reverse order of removal.