Overhaul

Part 1

Notes:
^ Grease bearings and sliding surfaces with polycarbamide grease, part number. G 052 142A2.
^ Adjusting shift control mechanism.





1. Shift knob
2. Bushing
3. Housing cover
^ Carefully, cry out latch in rear section of center console
4. Top part of retaining frame
5. Bottom part of retaining frame
6. Bushing
7. Sleeve
8. Nut, 8 Nm
9. Noise insulation cover
10. Shift control mechanism with shift housing
11. Nut, 10 Nm

Part II





1. Shift control mechanism with shift housing
2. Tensioning ring
3. Boot
^ Carefully pull over shift rod during removal
^ Set onto marks of shift rod and pivot rod when installing
4. Socket head bolt, 25 Nm
5. Clamp
6. Shift rod
^ Do not disconnect connecting rod Fig.-8- from shift rod; observe note
7. Nut, 25 Nm
8. Connecting rod
^ Do not disconnect from shift rod; observe note
9. Bolt, 25 Nm
10. Washer
11. Socket head bolt, 25 Nm
12. Front shift rod
^ With bearing bushing, bolt and washers
13. Bolt, 40 Nm
^ Part of front shift rod
^ Washers, which may have been installed between the pushrod and transmission must be reinstalled