Transmission Speed Sensor: Service and Repair

5 Speed A/T 01V

Sensor for transmission RPM -G182-, removing and installing

Note:
^ There is a distinction made between two types of transmission. Transmissions with hydraulic control E17,the sensor for transmission RPM (inductive sensory is secured to bottom of valve body. Transmissions with hydraulic control E1812, the sensor for transmission RPM (hall effect sensor) is secured to transmission housing behind valve body.
^ Information regarding which transmission is installed can be found in tables, Refer to Application and ID.

For transmissions with hydraulic control E17
Removing
- Removing valve body.





- Turn valve body on its back side and loosen connector at Sensor for transmission RPM -1-.





- Unbolt Sensor for transmission RPM -1- at valve body.

Installing
- Tighten Sensor for transmission RPM -1- using spacer sleeves -2- (height: 20 mm) to 7 Nm.
^ Installation position: Sensor-side with the connector terminals points to valve body center.





- Connect connector to Sensor for transmission RPM-1-.
- Installing valve body.
- Fill up ATF.

For transmissions with hydraulic control E1 8/2
Removing
- Removing valve body.





- Unbolt Sensor for transmission RPM -A- from transmission.

Installing
- Bolt on Sensor for transmission RPM -A- at transmission via bolt -B-. Tightening torque is 9 Nm.





- Route wire with connector -C according to illustration, so that the wire is not pinched when installing the valve body.
- Installing valve body.
- Fill up ATF.