Procedures
Headlights, Removing And Installing
NOTE: Protect bumper using cloth backed tape in headlight area to prevent damage to paint.
Removing
- Remove turn signal.
- Remove bolt (arrow) 6 Nm (53 in. lb).
- Remove two bolts (arrows) 6 Nm (53 in. lb).
- Disconnect headlight harness connector.
- Disconnect headlight beam adjusting motor harness connector.
- Pull headlight out from peg mount at side (approx. 15 mm), lift slightly and then lift out carefully toward front, rotating if necessary.
Installing
- Install in reverse order of removal.
- Always align headlights to adjacent body panels (gap clearances) before securing.
- Adjust headlights after assembly.