Output Diagnostic Test Mode (DTM) (Function 03)

Output Diagnostic Test Mode (Scan Tool Function 03)

NOTE:
- Output Diagnostic Test Mode may only be carried out on a stationary vehicle with the engine off.
- Switch on low beam headlights!
- Trace any malfunctions identified by the output DTM and replace the malfunctioning part if necessary.

Output DTM can carry out the following system tests:
- Lower headlights
- Raise headlights

Initiating output DTM:
- Press buttons -0- and -3- to select "Output Diagnostic Test Mode" function 03.

Indicated on display

Rapid data transfer HELP
03 - Output Diagnostic Test Mode

- Press -Q- button to confirm input:

Indicated on display

Rapid data transfer Q
03 - Output Diagnostic Test Mode

- Press -Q- button to confirm input.

This will start the Output Diagnostic Test Mode for the analog instruments (displays).

Indicated on display

Output Diagnostic Test Mode ->
Analog Indicators

The headlights are lowered until the next function is called up or they reach the bottom position.
- Press -> button.

Indicated on display

Output Diagnostic Test Mode ->
Headlights being raised

The headlights are raised until the next function is called up or they reach the top position.

- Press -> button.

Indicated on display

Output Diagnostic Test Mode ->
END

- Press -> button.

The scan tool returns to the "Select function" prompt.

Indicated on display

Rapid data transfer HELP
Select function XX