5 Spd. A/T 01V Front and All Wheel Drive

Wiring harness in transmission, removing and installing - 5 Spd. A/T 01V Front and All Wheel Drive

Removing

- Remove valve body

- Pry retaining tabs on electrical connectors on solenoid valves out with a small screwdriver and disconnect electrical connectors - A - one after the other.
- Disengage wiring harness at valve body side retaining tabs - B -.

- Disconnect electrical connector - arrow - at Transmission Vehicle Speed Sensor (VSS) G38 /Transmission Output Speed (RPM) Sensor G195.

Note:
^ Shown with valve body installed in illustration.

- Rotate valve body.

Transmission with hydraulic control "E17":

- Disconnect electrical harness connector at Transmission Input Speed (RPM) Sensor G182 - 1 -.
- Remove retaining clip - arrow A - and unclip wiring harness from retaining clip - arrow B -.

Installing

Installation is in reverse order of removal, note the following:

- Connect wiring harness electrical connectors to corresponding solenoid valves and sensors.
- Clip wiring harness into intended retaining clips. If deviated, the wiring harness could be pinched when installing the valve body.
- Install valve body.
- Fill ATF.