Electronics Box (E-Box) In Plenum Chamber, Removing and Installing

Electronics Box (E-box) In Plenum Chamber, Removing And Installing







- Remove mounting bolts (arrows) and pull off cover.
- When installing, press cover on by hand and tighten mounting bolts in diagonal sequence. Tightening torque: 4 Nm (35 in. lb) (also see information on cover).
- Remove engine control module and, if necessary, remove auxiliary relay panel/auxiliary fuse panel.
- Disconnect harness connector at connector station.
- Pull out engine wiring harness together with rubber grommet from opening in electronics box.







- Remove both nuts -A- (4 Nm or 35 in. lb).
- Lift electronics box off studs at rear and pull out of mount -B-.

Note the following when installing:
- Install in reverse order of removal.
- Always replace seal -C-: seal must not overlap opening in body and edge of sheet metal.