Transmission Input Speed (RPM) Sensor G182 (Transmission With Hydraulic Control "E18/2"), Removing and Installing

Transmission Input Speed (RPM) Sensor G182 (transmission with hydraulic control "E18/2"), removing and installing - 5 Spd. A/T 01V Front and All Wheel Drive

Note:
^ On a transmission with hydraulic control "E1812", Transmission Input Speed (RPM) Sensor G182 is a Hall sensor (secured behind valve body on transmission housing).
^ The allocation of the hydraulic control can be found in Technical Data.

Removing

- Remove valve body.





- Remove bolt - B -.
- Remove Transmission Input Speed (RPM) Sensor G182 - A - from transmission.

Installing

Installation is in reverse order of removal, note the following:

- Electrical connector - C - for Transmission Input Speed (RPM) Sensor G182 is clipped into valve body mount after installing valve body.
- Install valve body
- Fill ATF.

Torque specification