Inner Oil Line, Removing and Installing

Inner oil line, removing and installing - 5 Spd. A/T 01V Front and All Wheel Drive

Note:
^ Faulty O-rings on inner oil line allow ATF to leak into the final drive. This will lead to overfilling and oil will drip from the final drive breather hole.

Removing

- Remove valve body.





- Press inner oil line evenly off of transmission housing with a screwdriver.

Note:
^ Inner oil line cannot be removed without causing damage.

Installing

Install in reverse order of removal, note the following:

Note:
^ Replace O-rings.
^ Oil line may be installed with Oil Line Installer 3381. Otherwise the risk exists that the oil line may leak by bending.





- Insert oil line in Oil Line Installer 3381.
- Using light blows with a plastic hammer, drive oil line on Oil Line Installer 3381 into transmission housing as far as stop on tool.

^ Open side of oil line installer 3381 faces toward outer wall of transmission.
^ Do not distort oil line. Drive both line ends in equally.

- Install valve body.
- Fill ATF.
- Check oil level in front final drive.