Assembly Overview, Part II

Assembly overview, Part II - 6 Spd. Manual Transmission 01E





Note:
Removing and installing drive flange housing.

1 - Drive flange

^ When installing drive flange, circlip -7- should be inserted at the same time through hole in housing

2 - Seal
3 - Circlip
4 - Grooved ball bearing for drive flange
5 - Sleeve
6 - Baffle plate

^ Only press out if damaged

7 - Circlip

^ To remove drive flange, open out circlip

8 - O-ring

^ Always replace

9 - Bolt, 35 Nm

^ Secures drive flange housing to rear final drive housing

10 - Drive flange housing
11 - Bolt, 40 Nm

^ Secures final drive support to drive flange housing

12 - Final drive support
13 - Circlip
14 - Cover cap
15 - O-ring

^ Always replace