Installing

Installing - 5 Spd. Automatic Transmission 01V

Installation is reverse of removal, noting the following:

Notes:
^ After removing driveshaft, always remove any remaining locking fluid from thread holes in the transmission drive flanges and the rear final drive. Otherwise there is a possibility that the new bolts may get jammed when installed and shear when removed.
^ Cleaning can be performed with a tap.
^ Always replace seal between drive flange and driveshaft (remove protective film and attach seal to drive flange). Adhesive surface must be free of grease.
^ Replace driveshaft bolts (self-locking).

- Determine radial run-out at flange/driveshaft if a factory marking is present at the driveshaft and adjust color marking at driveshaft to new marking at flange.
- Install exhaust system free of stress
- Top-up and check gear oil in rear final drive.

Tightening torques