Front Final Drive and Transfer Case, Component Overview
Front final drive and transfer case, component overview - 5 Spd. A/T 01V Front and All Wheel Drive
Note:
^ Components shown in illustration can be removed with transmission installed.
1 - Internal hex bolt, 25 Nm
2 - Driveshaft output flange
3 - Shaft seal
^ Replace
4 - Bolt, 23 Nm
^ Qty. 4
5 - Housing cover
6 - O-ring
^ Coat with axle oil
7 - Circlip
8 - Grooved ball bearing
^ For spur gear 1
9 - Spur gear 1
^ For rear ring and pinion set
10 - Circlip
11 - Needle bearing
^ For spur gear 1
^ Remove only to replace
^ To replace transfer case housing, warm to approx. 100° C and drive needle bearing with drift towards rear (Attention! Wear protective gloves)
^ Drive in with Sleeve 30-21 to stop
12 - Bolt, 23 Nm
^ Loosen or tighten diagonally
13 - Transfer case housing
^ Can be replaced if damaged
14 - Clamping nut
15 - Needle bearing
^ Remove only to replace
^ Replace
16 - Circlip
17 - Spur gear 2
^ For rear ring and pinion set
18 - Grooved ball bearing
^ For spur gear 2
19 - Circlip
20 - Fastening plate
21 - Guide plate
22 - Bolt, 8 Nm
23 - Circlip
24 - Gasket
^ Replace
25 - Torsen differential
^ Replace complete unit if damaged
26 - Shaft seal
^ Replace
27 - Magnet
^ Replace
28 - Alignment bushing
^ Qty. 2
29 - Bleeder
^ For transfer case
^ With attached cover
^ Installation position: Without cover, breather must project 10 to 11 mm out of housing
30 - Bolt, 23 Nm
^ Loosen and tighten diagonally
31 - Intermediate flange for front final drive
32 - Gasket
^ Replace
33 - Alignment bushing
34 - Drive pinion
^ For front final drive
35 - Intermediate pinion
^ For front final drive
^ Installation position: gear identification faces toward differential
36 - Pinion gear
^ For front final drive
^ Installation position: gear identification faces toward differential
37 - Shaft seal
^ Replace
Pressing off grooved ball bearing for spur gear 1
A - Separating device 22 to 115 mm Kukko 17/2
Pressing on grooved ball bearing for spur gear 1
Pressing off grooved ball bearing for spur gear 2
A - Separating device 22 to 115 mm Kukko 17/2
Pressing on grooved ball bearing for spur gear 2