Cover For Transmission Housing and 5TH Gear

Cover for transmission housing and 5th gear, removing and installing
1. Hexagon bolt, 10 Nm
^ For transmission housing cover
2. Transmission housing cover

Notes: If the transmission cover is fitted with the transmission installed, check oil level as follows:
- Fill with oil up to lower edge of filler hole and fit filler plug.
- Start engine, engage gear and allow transmission to turn for approximately 2 minutes.
- Switch off engine and top up transmission oil to flower edge of filler hole again.
3. Gasket
4. Torx socket head bolt M10, 80 Nm
^ Fitted piece on bolt head holds saucer spring washer in position
5. Dished washer
^ Installing, Refer to Assembly Sequence.
6. Socket head bolt, 25 Nm
^ For pivot pin to transmission housing
7. Pivot pin
8. 5th gear selector fork
^ Disassembling and assembling, Refer to Selector Forks, Disassembling and Assembling.
^ Adjusting, Refer to Assembly Sequence.
9. 5th gear locking collar
^ Installation position, Refer to Assembly Sequence.
^ Adjusting, Refer to Assembly Sequence.
10. Synchro - hub with 5th gear and synchronizing ring
^ Disassembling and assembling, Refer to Input Shaft, Disassembling and Assembling.
11. Needle roller bearing
12. 5th speed gear
^ Installation position, Refer to Assembly Sequence.