Basic Setting For Window Regulator Motor, Activating

Basic Setting For Window Regulator Motor, Activating

NOTES:
- The following repair procedures must be completed after installation of replacement parts.
- All sealing and trim must be fully installed.
- Door and window regulator must be adjusted.
- Door must be fully assembled and closed.
- Follow the subsequent repair procedure carefully and without interruption.
- Breaks longer than 10 seconds are considered and interruption in "activation mode".

- Close door and turn ignition on.
- Run window up to top position (fully closed).
- Release window regulator switch.
- Pull window regulator switch up again, and hold in position longer than 1 second.
- Run window down to bottom position (fully open) by pressing window regulator switch down.
- Run window up to top position (fully closed).
- Release window regulator switch.
- Pull window regulator switch up again, and hold in position longer than 1 second.
- Basic setting for window regulator is now activated.
- Activate "one-touch" opening and closing function.