Rear Brakes, Servicing

1. Phillips - head screw, 4 Nm
2. Brake disc
^ Thickness: 9mm
^ Wear limit: 7mm
^ When worn, always replace both sides
3. Cap
4. Self-locking 12-point nut, 175 Nm
^ Replace each time after removing
5. Wheel hub with wheel bearing and rotor
^ Only replace complete
^ Removing and installing:
6. Hexagon bolt, 60 Nm
^ With dished spring
7. Splash plate
8. Stub axle
9. Handbrake cable
^ Adjusting Hand brake, Refer to Park Brake System, Adjusting.
10. Axle beam
11. ABS speed sensor
^ Before inserting sensor, clean fitting hole inner surface and coat with lubricating paste G 000 650
12. Hexagon socket head bolt, Tighten to 8 Nm
13. Hexagon socket head bolt, Tighten to 65 Nm
14. Brake carrier with guide pins and protective cap
^ Supplied as replacement part assembled with sufficient grease on guide pins
^ If protective caps or guide pins are damaged use repair kit. Use grease supplied to lubricate guide pins.
15. Brake hose/line
^ With banjo bolt and seals
^ Banjo bolt to brake caliper tightening torque 35 Nm
^ Do not disconnect brake hose when changing brake pads
16. Self - locking hexagon bolt, Tighten to 35 Nm
^ Replace
17. Brake caliper
^ Servicing, Refer to Brake Caliper, Service and Repair.
^ Adjust Hand brake cable first after maintenance or replacement

CAUTION: The foot brake must not be operated first adjusting Hand brake, Refer to Park Brake System, Adjusting

18. Brake pads
^ Thickness: 17 mm
^ Checking thickness: Repair information, Maintenance Always replace both sides
^ Always replace when changing pads