ABS/ESP ITT Mark 60

ABS/ESP ITT Mark GO, module and hydraulic unit

Exploded view

CAUTION: Interchanging brake line connections will result in ESP system malfunction.

^ After connecting brake lines to hydraulic unit, perform final control diagnosis.

Note: Final control diagnosis can be performed to establish whether line connections have been interchanged.





1. Cap nut - 20 Nm
2. Torx socket head bolt - 4 Nm
3. Brake line
^ Hydraulic unit to left rear brake caliper
4. Torx socket head bolt - 4 Nm
5. Brake line
^ Hydraulic unit to right rear brake caliper
6. ABS hydraulic unit -N55-
^ Installation location: in engine compartment, left side
7. Brake line
^ Brake master cylinder/primary piston circuit to hydraulic unit
8. Brake line
^ Hydraulic unit to left front brake caliper
9. Brake line
^ Hydraulic unit to right front brake caliper
10. Brake line
^ Brake master cylinder/secondary piston circuit to hydraulic unit
11. ABS Control Module (w/EDL) -J104-
^ Installed position in engine compartment, left side
^ The control module is bolted to the hydraulic unit
12. Cap nut - 20 Nm
13. Retainer
14. Bolt - 8 Nm