Navigation System

Plug connectors on reverse side of Control module for navigation with CD-mechanism -J401







1 - Terminal block with four multi-pin connectors and one fuse
2 - 20-pin multi-pin connector I consists of
Yellow 6-pin partial connector
Green 6-pin partial connector
Blue 8-pin partial connector
3 - Brown 8-pin multi-pin connector II
4 - Black 8-pin multi-pin connector III
5 - Red 10-pin multi-pin connector IV
6 - GPS antenna connection
7 - Securing bracket for antenna connection

Chamber Assignments Of Multi-pin Connectors I, II, III, IV On Reverse Side Of Control Module For Navigation With CD- Mechanism -J401

NOTE: Contacts which are not listed are vacant/unassigned.







20-pin multi-pin connector I
2 - CAN-Bus high (display)
5 - CAN-Bus low (display)
13 - NF+(to Radio)
14 - NF(-) Muting (to Radio)
15 - NF(-)(to Radio)
16 - Telephone NF (+) (from telephone)
17 - NF (-) Muting (telephone)
18 - Tel-NF-screen
19 - Telephone NF (-) (from telephone)







Black 8-pin multi-pin connector
1 - Gala (RPM signal)
2 - Reverse light switch
3 - K-diagnostic
4 - Terminal 15
7 - Battery + (terminal 30)
8 - Ground (GND) (terminal 31)