Square Housing

Brake light switch (square housing), removing and installing

Note: To ensure a secure fit, the switch may only be installed once.

Removing

- Remove storage compartment on driver's side.

- Unplug electrical connector.






- Remove brake light switch -1- by turning counter-clockwise through 90�.

Installing

Install in reverse sequence; note the following points:

- Pull brake light switch plunger fully out.

- Press brake pedal down as far as possible by hand.






- Guide switch through installation hole and secure by turning 90� clockwise -arrows-.

- Release brake pedal.

- Make sure proper function of brake lights when brake pedal is pressed and released.