Vehicles With Front Wheel Drive

Sender For Fuel Gauge -G, Removing And Installing

Removing


CAUTION!
Obtain the radio Anti-theft code from the customer before disconnecting the Battery Ground strap.







- Disconnect Battery Ground strap with ignition switched OFF.
- Open fuel tank cover briefly and close again.
- If necessary, drain fuel tank using fuel cart.


NOTE: The fuel tank must not be filled more than 1/3 maximum.


- Carefully pull cover flange out and push to the side with hoses connected.
- Disconnect harness connector for fuel level display on inside of cover flange.







- Pull sensor out of surge housing in fuel tank while simultaneously pressing latching tab -arrow-.


NOTE: For clarity, surge housing illustration is shown without tank.


Installing
Installation is performed in the reverse order of the removal procedure, when installing, note the following:
- Install the sender for fuel gauge in the guide on the surge housing outer section and press down until it engages.
- Wrap sender for fuel gauge wiring once around return line (in tank).
- Connect Ground strap to Battery with ignition switched OFF.
- After connecting Battery, input radio anti-theft coding.
- Run door windows up to stop with electric window lifters.
- Operate all window lifters again for at least 1 second in "closed" position to activate automatic up/down.
- Set the clock.