Power Trunk / Liftgate Lock Actuator: Service and Repair

Rear lid lock actuator, removing and installing

Removing







- Separate harness connector and detach vacuum line.
- Disengage operating rod -4- from clip -3-.
- Remove hex nuts -6- and remove lock actuator -7- from rear lid lock.







- Push out retaining pin -3- (2x) remove expanding clip.
- Push clip -4- back and disconnect.
- Remove lock actuator -1- from rear lid lock.

Installing
- Set lock cylinders in "open" position.







- Push ridged plate -1- to left. The first ridge of the plate -1- must snap into the first groove on the grooved segment -2-.