Removing and Installing

5 Speed Automatic 01V

Automatic Transmission Control Module (TCM) -J217-, removing and installing

Removing






- Remove lower right A-pillar trim and right front door sill trim.
- Detach carpeting from right inside door sill, and raise carpeting approx. 20 cm.
- Unclip box at -A- by pulling it upward.
- Unclip box at -B- as shown.






- Unclip TCM from box (arrows).
- Release catch on multi-pin connector and disconnect connector from TCM See Fig.3

Installing:
Install in reverse order of removal, with the following additional steps:






- Check that clip nut -1- is properly secured.