Rear Door Window Glass: Adjustments

Rear window, adjusting
- Make reference mark (measurement -a- = 9 mm) on window using water soluble pen at height of B-pillar.







- Place window on window regulator.
- Run window almost all the way up.
The window -1- and the seal -4- for the door component carrier must be parallel to each other in the vicinity of roof and C-pillar.
- Push window -1- in direction of B-pillar -3-.


NOTE: Window -1- must submerge 9 mm (measurement -a-) into seal -4- for door component carrier -3-.


- Tighten bolts on mount at window regulator.
Tightening torque: 2.5 Nm (22 in. lb)
- Run window -1- all the way up.
- Check measurement -a- and erase reference marking.