Central Locking Components, Assembly Overview

Central Locking Components, assembly overview







1 - Door control module, front right -J387-
- Integrated in window lifter motor.
2 - Door control module, rear right -J389-
- Integrated in window lifter motor.
3 - Tank cap release motor -V155-
- Removing => Fig 2
4 - Rear lid release motor -V139-
5 - Door control module, rear left -J388-
- Integrated in window lifter motor.
6 - Door control module, front left side -J386-
- Integrated in window lifter motor.
7 - Convenience system central control module -J393-
- Disassemble front left seat before removing
- Remove lower A-pillar trim.
8 - Hood contact switch -F266-
- Location: in lock carrier

Fig. 1 Removing convenience system control module -J393-







- Front left seat and lower A-pillar trim removed.
- Ignition off.
- Open control module box -1-.
- Disconnect connector from control module -2- and take out.

Fig. 2 Removing tank cap release motor -V155-







- Disconnect connector.
- Loosen bolts -arrows-using special tool T 10010, pull actuator -1-forward and remove.
- Before installing actuator, push emergency release -3- over locking pin.
- Locking pin of actuator must advance cleanly into closed tank cap -2-.