Door Lock, Removing and Installing (Rear Doors)

Door Lock, Removing And Installing







Removing
1 - Rear door
2 - Grommet
3 - Backing plate
4 - Door lock
- Door trim removed.
- Window frame and window lifter removed.
- Disconnect connector at door lock.

NOTE: To re-install door lock, unhook upper clip of swivelling lever from door handle.
If you are installing a new door lock, release operating rod from door lock

- Release operating rod from door lock by unclipping collar.
- Remove multi-point head cap bolts -6- and remove door lock.

5 - Bowden cable for interior door handle mechanism
- Installing => Fig 1
6 - M8 multi-point socket head bolt
- 20 Nm

Installing
Installation is reverse of removal.

Fig. 1 Hooking Bowden cable in door lock







- First insert Bowden cable -2- vertically in release lever -3- then swivel 90 degrees and secure in place by clipping into door lock -1- (see exploded view).

Fig. 2 Engaging operating rod in door lock







- When installing a new door lock, clip operating rod -1- into casing.
- Move slide -2- of casing upward to engage operating rod.
- Pull out securing pin -3- from door lock.