Drive Chain Gear For Oil Pump, Removing and Installing

Drive chain gear for oil pump, removing and installing
Special Tools and Equipment





^ 30-100 press tube

Removing
^ Remove front sealing flange.





^ Using claw remover -2-1 remove crankshaft chain sprocket while protecting crankshaft end with appropriate washer -1-.





Installing
Installation is reverse of removals:
^ Warm chain sprocket in oven at 220°C for approximately 15 minutes.

WARNING: Wear protective gloves!

^ Using pliers install chain sprocket on crankshaft end and slide onto crankshaft to stop using 30-100 press tube.