Three-way Halogen Headlights, Overview

Three-way Halogen Headlights, Overview


CAUTION!
Disconnect the battery Ground (GND) strap before working on the electrical system.


NOTE:
- Before disconnecting the battery, determine the correct coding for the anti-theft radio.
- After reconnecting the battery, check and activate the vehicle's electrical equipment (radio, clock, comfort and convenience features, etc.).
- Some procedures could affect the headlight beam adjustment, requiring that it be reset.
- Adjusting spray for headlights washer nozzles.







1 - Diffuser lens
2 - Retaining clamps (7x)
- To remove, carefully pry out using screwdriver
- To install, press in by hand
3 - Headlight frame
- Locked within headlight housing
4 - Seal for lens
- Always replace
5 - Reflector
- To remove, clip out of retaining rings
- To install, carefully press into retaining rings
- Do not touch inside of reflector
6 - High beam bulb
- 12 V 55 W (H7)
7 - Front fog light bulb
- 12 V, 55 W (H1)
8 - Low beam bulb
- 12 V, 55 W (H7)
9 - Wiring with harness connector
10 - Trim strip
- Clipped onto headlight housing
11 - Fixed bearing for reflector
- Only on vehicles without headlight automatic vertical aim control
12 - Cover
- Press lock down and remove toward rear
13 - Headlight - housing
14 - Bulb socket
15 - Turn signal bulb
- 12V, 21 W orange
16 - Turn signal lens