Ribbed Belt For Generator, Vane Pump and A/C Compressor

Ribbed belt for vane pump, generator and A/C system

Note: Before removing ribbed belt, note direction of rotation with chalk or felt-tip marker. Reversing the direction of rotation of a run-in belt can destroy the belt.

1. Ribbed belt
^ Check for wear
2. 23 Nm
3. Generator
4. 45 Nm
5. 23 Nm
6. Bracket
^ for generator
7. 40 Nm
8. Ribbed belt tensioner
9. 23 Nm
10. Belt pulley
^ for power steering pump
^ Use 3212 spanner wrench to counterhold when removing and installing
^ Identification: Front
11. Seal
^ Always replace
12. Banjo fitting - 47 Nm
13. Pressurized line
^ to power steering
14. Power steering vane pump
15. Bracket
^ for power steering pump
16. 23 Nm
17. 23 Nm
18. Bracket
^ for A/C compressor
19. 23 Nm
20. 23 Nm
21. 25 Nm
22. A/C compressor
^ Do not unscrew or disconnect refrigerant lines
^ After removing, secure compressor to chassis (i e with wire) Do not hang on refrigerant lines
23. Socket
^ for A/C compressor
^ 2x
24. Harmonic balancer
25. 23 Nm
26. 23 Nm