Crankshaft Main Bearing

Crankshaft bearing cap
^ Replace bolts A and nuts -1- to -8-.
^ Inserting alignment bushings into cylinder block
^ Tighten bearing cap nuts or bolts in the following sequence:
1. - Screw in bolts -A- hand tight.
2. - Tighten nuts -1- to -8- to 35 Nm.
3. - Tighten nuts -1- to -8- 90° (1/4 turn) further using rigid wrench.
4. - tighten bolts -A- to 20 Nm.
5. - Tighten bolts -A- 90° (1/4 turn) further using rigid wrench.