Integrated Child Seat, Retrofitting

Integrated Child Seat, Retrofitting

NOTE: Only vehicles as of VIN 4BWN 092 200 can be retrofitted.







1 - Seat bench with integrated child seat

CAUTION: Mounting brackets must always be installed.

- Remove rear seat
- For vehicles without mounting bracket, install mounting bracket
- Enlarge cut-out in floor mat near the plastic sleeves - 4 - by approx. 90 mm toward outside.
- Install seat bench with integrated child seat - 1 -.







- Mark holes - 3 - through bolt holes - 5 -.
- Remove seat bench - 1 -.
- Drill holes - 3 - for threaded inserts - 2 - Dia. 9mm.
- Remove drill shavings.
- Restore paint structure.
- Install threaded inserts using VAG 1618A.
- Install seat bench with integrated child seat - 1 -.
2 - Threaded insert (4x)
3 - Holes (4x)
4 - Plastic sleeves
5 - Bolt holes (4x)
6 - Bolts (4x)
- Tightening torque: 12 Nm (9 ft lb)