With Hydraulic Control E17

5 Speed Automatic 01V

Overview of removed components for transmissions with hydraulic control E17





1. Drain plug -40 Nm (30 ft. lbs.)
^ 5 mm hex socket
2. Seal
^ Always replace
3. Bolt 10 Nm (7 ft. lbs.)
^ Tighten bolts for oil pan diagonally in several stages
4. Oil sump
5. Gasket
^ Always replace
6. Oil strainer
7. Bolt - 8 Nm (70 inch lbs.)
^ For attaching valve body: 1 bolt M6 x 30, 16 bolts M6 x 60
8. Valve body
9. Bolt - 8 Nm (70 inch lbs.)
10. Bracket
^ For wiring harness
^ Insert wiring harness
^ Attached with bolts for valve body
11. Bolt - 6 Nm (53 inch lbs.)
12. Transmission - Vehicle Speed Sensor -G38
13. Spacer sleeve
^ Height: 8 mm
14. Inner oil line
^ Always replace
15. O-ring
^ Always replace
16. Speedometer - Vehicle Speed Sensor -G22
17. O-ring
^ Always replace
^ Coat with petroleum jelly
18. Multi - Function Transmission Range Switch -F125
19. Bolt - 8 Nm (70 inch lbs.)
20. O-ring
^ Always replace
21. Locking clasp
22. Wiring harness
^ Transmission Fluid Temperature Sensor -G93 integrated in wiring harness
^ Release from bracket for wiring harness -item 10
^ Location of wiring harness connector: flat point of rear shoulder faces down, the lugs on the shoulder are horizontal
23. Bolt - 6 Nm (53 inch lbs.)
24. Transmission - Input Speed Sensor -G182
25. Spacer sleeve Height: 20 mm
26. Screw - 6 Nm (53 inch lbs.)
27. Bracket
^ For solenoid valve
28. Solenoid Valve 4 -N91
^ With O-ring
29. Solenoid Valve 3N90
^ Without O-ring
30. Solenoid Valve 2 -N89
^ Without O-ring
31. Screw - 6 Nm (53 inch lbs.)
32. Bracket
^ For solenoid valves
33. Solenoid Valve 6N93
^ With O-ring
34. Solenoid Valve 7N94
^ With O-ring
35. Solenoid Valve 5N92
^ With O-ring
36. Solenoid Valve 1 -N88
^ Without O-ring
^ When installing, do not tighten bolts for guide plate (23 Nm) when selector lever is in position "P".
37. Bolt- 6 Nm (53 inch lbs.)
38. Magnet
^ 4 magnets in the beads of oil pan
39. O-ring
^ Always replace
40. ATF filler plug -80 Nm (59 ft. lbs.)
^ 17 mm hex socket