Engine: Application and ID

Technical data

Engine identification

Note: Engine identification is visible first after preparations.





- Remove front engine cover (arrows).





A sticker containing "engine code" and "production number" (arrow) is located on the housing for vacuum diaphragm for intake manifold adjustment.
If the sticker is not present and the "engine identification" is required, proceed as follows:





- Remove rear engine cover (arrows).





Engine codes are stamped on rear of cylinder block, left side (arrow).
Engine codes are also included on the vehicle data plate.
If the sticker is not present and the "engine identification" and "production number" is required, proceed as follows:





- Remove bolts (arrows) and remove vacuum diaphragm for intake manifold adjustment.
- Remove compression spring, which is behind it and set off to the side the vacuum diaphragm with connected lines.





The engine code -arrow- ("engine code" and "production number") are located at the front of cylinder head, on top.