Drive Chain Gear For Oil Pump, Removing and Installing

Drive chain gear for oil pump, removing and installing

Special Tools and Equipment





^ 30-100 press tube

Removing





- Remove front sealing flange, Refer to Timing Cover, Service and Repair.
- Using standard claw remover-2- , remove crankshaft chain sprocket while protecting crankshaft end with appropriate washer -1-.

Installing
Installation is reverse of removal, noting the following:

- Warm chain sprocket in 220°C oven for approximately 15 minutes.

WARNING: Wear protective gloves!





- Using pliers install chain sprocket on crankshaft end and slide onto crankshaft to stop using 30-100 press tube.