Glove Compartment: Service and Repair

Glove Box And Bracket For Glove Box, Removing And Installing







1 - Knee bar
- For passenger side
- Removing
- Open glove box.
- Remove lock cylinder and glove box push button.
- Remove screws 9.
- Remove knee bar trim - 2 -.
- Remove screws - 10 -.
- Remove kneebar retaining panel - 15 - from bracket - 8 -.
- Disconnect connector for illumination.
- Remove kneebar.







- Installing
- Adjust glove box with adjustment angle - 16 - and cam - 20 -.
- Adjust height at elongated hole at spring nut - 19 -.
- Adjust toward front and rear using screw - 17 -.
- Perform lateral adjustment by adjusting cam - 20 -.
- Loosen screw - 21 - and adjust cam lever - 22 - for lateral adjustment.
- Tighten screw - 21 -.
2 - Kneebar trim
3 - Support left
- Remove screws - 11 -.
4 - Support right
- Remove screws - 12 - and - 13 -.
5 - Retaining bracket
- Remove screws - 14 -.
6 - Bracket
- For knee bar, left
- Unhook at passenger airbag frame







7 - Bracket
- For knee bar, right
- Unhook at passenger airbag frame
8 - Bracket
9 - Bolt
- 2.5 Nm (22 in.lb.)
- Qty. 2
10 - Bolt
- 2.5 Nm (22 in.lb.)
- 2 parts
- Qty. 4
11 - Screw
- 22 Nm (16 ft.lb.)
- Qty. 2
12 - Screw
- 22 Nm (16 ft.lb.)
13 - Screw
- 15 Nm (11 ft.lb.)
14 - Screw
- 22 Nm (16 ft.lb.)
- Qty. 2







15 - Retaining panel
16 - Adjustment angle
17 - Bolt
- 2.5 Nm (22 in.lb.)
18 - Washer
19 - Spring nut
20 - Cam
21 - Bolt
- 2.5 Nm (22 in.lb.)
22 - Cam lever