Tailgate, Removing And Installing

Tailgate (Avant)

Tailgate, Removing And Installing

- Remove tailgate trim.
- Disconnect or remove harness connectors and hoses (i.e. for central locking and rear window washer system).
- Prop up and secure tailgate in open position.
- Lift retaining spring slightly using small screwdriver and pull gas-filled strut - 1 - off lower ball stud.







- Using screwdriver, lift retaining spring - 3 - as shown and remove gas-filled strut spring - 1 - from upper ball stud - 2 -.

NOTES:
- After completely removing the gas-filled strut, check to make sure it is correctly positioned when installed.
- Sound deadening components must be installed on the body side.
- To install, press gas-filled strut onto ball studs so that it engages in position.
Ball stud tightening torque: 15 Nm +0/-1 Nm (11 ft lb +0/-9 in.lb)







- Unscrew socket-head screws - 1 - (2x) from tailgate - 5 -.
Tightening torque: 21 Nm (15 ft lb)
- Remove tailgate.