Front Axle

ABS wheel speed sensor, removing and installing

Removing
- Loosen wheel bolts.
- Raise vehicle.
- Remove wheel.





- Remove grommet -1- from wheel housing.
- Disconnect ABS wheel speed sensor harness connector -2-.
- Disconnect ABS wheel speed sensor wiring from retainers (arrows).
- Pull ABS wheel speed sensor out of wheel bearing housing.
When installing, pay particular attention to the following points
- Replace clamping sleeve, Refer to Brakes and Traction Control; Service and Repair.
- Before installing speed sensor, install sealing cuff.
- Connect ABS wheel speed sensor wiring and snap grommets into retainers.
- Turn wheels completely to left and right stop positions and check ABS wheel speed sensor wiring clearance.