Check DTC Memory (Scan Tool Function 02)

Check DTC Memory (Scan Tool Function 02)

NOTE: The displayed malfunction is only updated when the On Board Diagnostic (OBD) program is initiated or when "Erase DTC Memory" function 05 is used.

- Switch on printer by pressing PRINT button (indicator lamp in button lights up).

Indicated on display

Rapid data transfer HELP
Select function XX

- Press buttons -0- and -2- to select "Check DTC Memory" function 02.

Indicated on display

Rapid data transfer Q
02 - Check DTC Memory

- Press -Q- button to confirm input.

Indicated on display(the number of stored DTCs)

X DTC recognized!

Stored DTCs are displayed and printed out one after the other.
- Check printout against DTC table and repair all malfunctions as necessary. Radio, Telephone, Navigation - On Board Diagnostic (OBD)


No DTC recognized! ->

If "No DTC recognized" is displayed the program will return to the starting point ("Select function XX" prompt) after the -> button is pressed.

Indicated on display

Rapid data transfer HELP
Select function XX

If anything else is displayed:
Scan Tool operating instructions
- End output (function 06). End Output (Scan Tool Function 06)
- Switch ignition off and disconnect connections from Data Link Connector (DLC).