A/C Compressor Bracket (Zexel Compressor), Removing and Installing

A/C Compressor Bracket (6-cyl. Engine - Zexel Compressor), Removing And Installing







- Remove front noise insulation panel under engine, and detach complete front bumper/grille assembly (service position).
- Remove ribbed belt.
- Remove oil filter

CAUTION:
- Do not discharge refrigerant system and do not disconnect refrigerant hoses from compressor unless removing or replacing compressor.
- Mark running direction of ribbed belt before removing (if belt is installed in the opposite running direction, belt damage may result.
- Cover sealing surface for oil cooler on engine block before removing compressor.
- After loosening/removing compressor, attach to frame member e.g. with wire; do not suspend compressor from coolant hoses.

1 - Nut
2 - Washer
3 - Compressor mounting bracket
4 - Hex socket bolt with washer
- 25 Nm (18 ft lb)
5 - Compressor with clutch
- 25 Nm (18 ft lb)
6 - Washer
7 - Bolt
- 25 Nm (18 ft lb)
8 - Refrigerant hose bracket
- Attach to refrigerant hose clip first