Basic Setting (Function 04)

Basic Setting (scan Tool Function 04)

After replacing a headlight, level sensor or control module, the basic setting must be initiated. The following points must be taken into account:
- Vehicle must be in precisely defined load condition.

NOTE: For the applicable nominal values and prerequisites for the load condition.

- Settle vehicle (bounce vehicle on suspension several times, then allow vehicle to come to a rest).

Initiating Basic Setting
- Press buttons -0- and -4- to select "Basic Setting" function 04.

Indicated on display

Rapid data transfer Q
04 - Basic Setting

- Press -Q- button to confirm input.

Indicated on display

Basic Setting Q
Input display group number XXX

- Press buttons -0-, -0- and -1- to input display group number 001.
- Press -Q- button to confirm input.

Indicated on display

System in Basic Setting 1 ->
Please wait...

- Headlights move into adjustment position.

Indicated on display

System in Basic Setting 1 ->
Adjust headlights

- Headlights are now in adjustment position. Turn on headlights. Basic Setting 1 turns off the adjustment operation and "Headlights not adjusted" is stored in DTC memory.
- Press -> button.

Indicated on display

Rapid data transfer HELP
Select function XX

- Press buttons -0- and -4- to select "Basic Setting" function 04.

Indicated on display

Rapid data transfer Q
04 - Basic Setting

- Press -Q- button to confirm input.

Indicated on display

Basic Setting Q
Input display group number XXX

- Press buttons -0-, -0- and -2- to input display group number 002.
- Press -Q- button to confirm input.

Indicated on display

System in Basic Setting 2 ->
Ctrl. pos. learned

The control module has now learned that this position is the Home position. The DTC "Headlights not adjusted" is erased and normal operation resumes.
- Press -> button.

Indicated on display

Rapid data transfer HELP
Select function XX