Wiring Harness In Transmission, Removing and Installing

Wiring harness in transmission, removing and installing - 5 Spd. Automatic Transmission 01V

Removing

- Remove valve body.

- Lever out retainer straps of connectors at solenoid valves using a small screwdriver and disconnect connectors -A- in sequence.
- Unhook wiring harness at side retainer straps -B- of valve body.

Only for Park/Neutral Position (PNP) Switch -E17-

- Turn valve body on its back side and loosen connector at Sensor for transmission RPM -1-.
- Remove retaining clip (arrow A) and unclip wiring harness from retaining clip (arrow B).

Installing, valid for all:

Installation is reverse of removal, noting the following:

- When installing, connect connectors of wiring harness to the corresponding solenoid valves.
- Clip wiring harness into the respective retaining clips. In case of deviations, the wiring harness can be pinched during installation of the valve body.
- Install valve body.
- Fill up ATF.