Headlight, Removing and Installing

Headlight, Removing and Installing

Removing:


NOTE: Apply masking tape to the bumper in front of the headlight to prevent damage to the paint.


- Loosen bolts at front bumper brackets and pull out bumper approx. 5 - 10 cm (2 to 4 in.).
- Remove front turn signal lights.
- Disconnect 5-pin connector at headlight wiring harness.







- Remove screw -1- and remove trim -2-.
- Remove four screws -3- and pull out headlight assembly toward front.

Installing:
- Adjust and tighten headlight assembly maintaining even gaps all around.
- Continue installation in reverse order of removal.
- Adjust headlights.