Door Lock, Removing and Installing

Door Lock, Removing And Installing

Removing
- Remove front door trim.
- Remove lock cylinder housing







- Unclip clip-1-from door handle.







- Remove screws -2- from front door -1 -.
- When installing, tighten screws to 20 Nm.

Installing







1 - Door lock


CAUTION: Door lock is only to be installed with lock lever in basic position.


2 - Spring
3 - Lock lever
- Basic position
- Slightly pull lock lever out in direction of arrow.
- Let spring engage in lock lever.
- Spring will bring lock lever into basic position.
4 - Cable
- May only be clipped into door handle with lock lever in basic position
- Cable should not be under tension when it is clipped into door handle
5 - Door handle







Fig. 1 Engaging Bowden cable for interior release mechanism in door lock
- Insert Bowden cable -1- in direction of arrow -A- in lock lever, then turn through 90 degrees in direction of arrow -B-.
- Clip Bowden cable into door lock -2- in direction of arrow -C-.
- Clip in trim -3- for door lock.