Fuel Tank: Testing and Inspection

- Observe safety precautions.
- Observe rules for cleanliness.

Special tools and equipment







- VAG1433A

Procedure
- Note radio code (for vehicles equipped with coded anti-theft radio). Obtain if necessary.







- If installed, remove cover above battery.
- Open battery protective casing (Velcro).







- Switch ignition off and disconnect battery Ground (GND) strap (arrow).

A - Procedure for more than 3/4 full fuel tank
- Remove fuel filler cap from fuel filler unit.
- Mark a measurement of 980 mm on a hose with an external diameter of 11-15 mm.







- Insert hose -3- into fuel filler unit up to this marking (arrow).







NOTE:
- On the lower end of the fuel filler unit, there is a spherical valve -2- in the fuel tank -1-, which must not be excessively pressured or damaged via the siphoning hose -3-. Therefore, hose should only be inserted to marking.
- If the hose can only be inserted with difficulty, smear it with engine oil. Never use lubricants containing silicon.


- Connect hose to siphoning hose to VAG1433A using appropriate adapters.
- Remove fuel from tank as much as possible via fuel filler unit.
- Carefully remove siphoning hose.
- Removing fuel pump. Refer to "Fuel Pump, Removing and Installing (Front wheel drive)", Service and Repair
- Siphon remaining fuel through opening for fuel pump.

B - Procedure for less than 3/4 full fuel tank
- Removing fuel pump. Refer to "Fuel Pump, Removing and Installing (Front wheel drive)", Service and Repair
- Siphon fuel through opening for fuel pump.