Programming and Relearning

Adaptation (Function 10)

Requirements:
- Connect VAS 5051 Scan Tool (ST). Connecting VAS 5051 Tester
- Switch on ignition.

Implementing function "10 - Adaptation"

Indicated on display:


Rapid data transfer HELP
Select function XX


- Press buttons -1- and -0- to select "Adaptation".

Indicated on display:


Rapid data transfer Q
10 - Adaptation


- Confirm entry with -Q-button.

Indicated on display:


Adaptation
Feed in channel No. XX


- Press buttons -8- and -1- to select "Channel" 81.

NOTE: Incorrect entries can be corrected after pressing the C key.

- Confirm entry with -Q-button.

Indicated on display:


Channel 81 Adaptation 1->
PIN ? <-1 3->


- Enter 20771 and press the -> button.

Indicated on display:


Channel 81 Adaptation 20771 ->


- Press the -> button.

Indicated on display:


Channel 81 Adaptation 20771 Q
Store changed value?


- Confirm input with -Q-button.

Indicated on display:


Channel 81 Adaptation 20771->
Changed value is stored.


- Press the -> button.

Indicated on display:


Rapid data transfer HELP
Select function XX


- Press buttons -0- and -6- to select "End output".

If the Adaptation value (PIN) is incorrectly entered three times, the Adaptation function will be disabled.

Indicated on display:


Channel 81 Adaptation 00000 Q
Disabled 10


The current disabled time in minutes (e.g. 10) is indicated in field 2, on the bottom line.
- Press the -Q-button.
- Initiate Adaptation again after the indicated disabled time has elapsed.

If Adaptation is performed and no new vehicle data is available, the following appears:

Indicated on display:


Channel 81 Adaptation 00000->
Bus not OK


- Press the button.

In this case, Adaptation is not necessary.