Wiring to Mass Air Flow (MAF) Sensor -G70-, Checking
Wiring To Mass Air Flow (MAF) Sensor -G70-, Checking
NOTE: The signal wire is also checked during the wiring check.
- Connect test box V.A.G 1598/31 to wiring harness for Engine Control Module (ECM); do not connect Engine Control Module (ECM). Wiring and Component Testing Using VAG1598/31 Test Box
- Check for open circuit, short to positive, or short to ground (GND) in following wiring connections:
Connector terminal Test for VAG 1598/31 Socket
3 27
4 53
5 29
- Repair any open/short circuit as necessary.
- Additionally check all wires for short to one another.
If the wiring is OK:
- Replace Mass Air Flow (MAF) sensor -G70-.