Fuse Box, Removing and Installing

Fuse Box, Removing And Installing

Removing
- Remove driver's storage compartment







- Remove bolts -1- for fuse box-2-.
- Remove fuse box from center tube for instrument panel.
- Detach wiring harness on center tube for instrument panel and set aside.







- Cut cable tie -1-.
- Release cover for fuse box -arrows-.
- Pull fuses from fuse box.







- Pull off retaining strip for connectors -arrows- and remove connectors from fuse box.
- Unclip base -1-.


NOTE:







Check the exact assignment for fuse carrier in the current wiring diagram.

Installing
Installation is reverse of removal, paying attention to the following:


NOTE: All cable ties opened or cut during removal must be reinstalled at the same locations during installation.


Tightening torque
Fuse box to center tube for instrument panel: 3 Nm