Initiating & Checking Control Module Versions

On Board Diagnostic (OBD), Initiating Program

Test requirements:
- Voltage supply and fuses for appropriate systems OK.
- Connecting VAS 5051 scan tool Connecting VAS 5051 Tester
- Switch ignition on.

NOTE:
- If no display appears, use wiring diagram to check power supply for VAS 5051
- Additional operating instructions can be called up by pressing the Scan Tool HELP button.
- The next step in the program sequence can be selected by pressing the button.
- Incorrect entries can be terminated by pressing the -C-button..

- Switch on printer by pressing Print button (indicator lamp in button lights up).
- Press button -1- for "Rapid data transfer".

Indicated on display:


Rapid data transfer HELP
Enter address word XX


Address word for driver's seat memory system: 36
- Press buttons -3- and -6-.

Indicated on display:


Rapid data transfer Q
36 - Driver's seat adjustment


- Confirm entry with -Q-button.

Indicated on display:


Rapid data transfer HELP
Tester transmits address word 36


If "No control module response" appears on the display: Close door, then open again and keep open. Re-start On Board Diagnostic (OBD).


Rapid data transfer HELP
No control module response


8E0959760 Seat memory R2 OE01 ->


- Display appears after approximately 5 seconds:
- Press the -> button.

Indicated on display:


Rapid data transfer HELP
Select function XX

NOTE: Pressing the HELP button will print out a list of possible functions:

On Board Diagnostic (OBD) functions

Possible functions:
02 - Check DTC Memory
04 - Basic Setting
05 - Erase DTC Memory
06 - End Output
07 - Code Control Module
08 - Read Measured Value Block
10 - Adaptation